Data set 01
1960 RCA Industrial and Communications Types
Published operating points and test conditions from this source.
SECTION 1
Pentode
Characteristics
Heater Voltage
6.3 V
Heater Current
175 mA
Voltage Pentode - Sharp Cutoff (single) ·Pentode
6096
Ruggedized sharp-cutoff miniature pentode for high-frequency wide-band radar and IF service in military and industrial airborne equipment. Low heater drain, high transconductance, and low capacitances support demanding broadband amplification.
Directly heatedCold cathodeCommon cathodeDissimilar
- Sections
- 1
- Base
- -
- Socket code
- B7G
- Base pins
- 7
- Nominal heater
- 6.3 V / 175 mA
Description
Ruggedized sharp-cutoff miniature pentode characterized by low heater power, high transconductance and low capacitances for high-frequency wide-band radar and IF service in military and industrial airborne equipment.
Socket description
Miniature 7-contact
General specifications
Tube and section characteristics
Properties common to every published source and operating point.
Heater and base
- Base
- -
- Socket code
- B7G
- Base pins
- 7
- Nominal heater voltage
- 6.3 V
- Nominal heater current
- 175 mA
- Parallel heater voltage
- -
- Parallel heater current
- -
- Series capable
- No
Terminal pinout
Electrical assignments shared by every tube using this base designation.
No verified pinout is recorded for this base designation.
Section ratings
1 physical section, each with unique specifications.
Section 1
Pentode
X-ray radiationInterelectrode capacitances
- Plate resistance
- 340000 Ω
- Transconductance
- 0.005 S
- Max plate voltage
- 200 V
- Max screen voltage
- 155 V
- Max plate dissipation
- 1.65 W
- Max screen dissipation
- 0.55 W
- Max cathode current
- 20 mA
Alias/co-designation from 5654/6AK5W/6096 source.
Source-dependent data
Operating conditions by source
Each block preserves the test conditions and published values from one reference. Values from different sources are intentionally kept separate.
Data set 02
1966 Tung Sol Electronic Tubes 3 of 4
Published operating points and test conditions from this source.
SECTION 1
Pentode
Other
Heater voltage
6.3 V
Heater current
175 mA
Plate voltage
120 V
ClassA
Screen voltage
120 V
ClassA
Cathode bias resistor
200 ohm
ClassA
Plate current
7.5 mA
ClassA
Screen current
2.5 mA
ClassA
Maximum plate voltage
200 V
Maximum screen voltage
155 V
Maximum plate dissipation
1.65 W
Maximum screen dissipation
0.55 W
Maximum cathode current
20 mA