Rectifier - Half Wave ·Rectifier
Directly heated high-voltage half-wave rectifier intended primarily to supply accelerator or anode voltage to cathode-ray tubes at very low current.
A directly heated half-wave rectifier designed primarily to supply accelerator or anode voltage to cathode-ray tubes, rated for very high voltage and low rectified current.
European 4-pin base
General specifications
Properties common to every published source and operating point.
Electrical assignments shared by every tube using this base designation.
No verified pinout is recorded for this base designation.
1 physical section, each with unique specifications.
Section 1
Published ratings and characteristics promoted from the approved datasheet.
Source-dependent data
Each block preserves the test conditions and published values from one reference. Values from different sources are intentionally kept separate.
Data set 01
Published operating points and test conditions from this source.
Heater Voltage
2 V
Published datasheet value
Heater Current
250 mA
Published datasheet value
Anode Voltage RMS
5000 V
Published datasheet value
Rectified DC Current
2 mA
Published datasheet value
Data set 02
Published operating points and test conditions from this source.
Anode RMS voltage
5000 V
Published datasheet value
Data set 03
Published operating points and test conditions from this source.
Heater/filament voltage
2 V
Peak inverse voltage
10000 V
Nominal/maximum output current
5 mA
Rectifier topology
Half-wave