Skip to main content

Rectifier - Full Wave ·Rectifier-Rectifier

U10

Directly heated full-wave rectifier for modest AC power supplies, providing approximately 60 mA DC output for receiver and general electronic equipment.

Directly heatedCold cathodeCommon cathodeDissimilar
Sections
2
Base
-
Socket code
B4
Base pins
-
Nominal heater
4 V / 1 A

Description

Full-wave rectifier providing up to 60 mA at 250 V.

Socket description

European 4-pin base

General specifications

Tube and section characteristics

Properties common to every published source and operating point.

Heater and base

Base
-
Socket code
B4
Base pins
-
Nominal heater voltage
4 V
Nominal heater current
1 A
Parallel heater voltage
-
Parallel heater current
-
Series capable
No

Terminal pinout

Electrical assignments shared by every tube using this base designation.

No verified pinout is recorded for this base designation.

Section ratings

2 physical sections, each with unique specifications.

Section 1

Rectifier

X-ray radiationInterelectrode capacitances
Rectifier nominal output current
60 mA

Published maximum ratings and characteristics audited; remaining useful numerical data retained in parameter table.

Section 2

Rectifier

X-ray radiationInterelectrode capacitances
Rectifier nominal output current
60 mA

Physical rectifier section 2; identical section values duplicated per physical-section policy.

Source-dependent data

Operating conditions by source

Each block preserves the test conditions and published values from one reference. Values from different sources are intentionally kept separate.

Data set 01

192X Marconi Valve

Published operating points and test conditions from this source.

SECTION 1

Rectifier

Other

  • DC output voltage

    250 V

    Published approximate operating data

Data set 02

1955 Marconi

Published operating points and test conditions from this source.

SECTION 1

Rectifier

Other

  • —. |Recririep CurReNT Max

    60 mA

    —. |Recririep CurReNT Max. 60.MA.

  • IMPEDANCE

    220 ohm

    IMPEDANCE 220.0HMs, /

  • | L T

    4 A

    | L T 4 ] ing rectified current to the field wind-

  • FILAMENT VOLTS

    40

    FILAMENT VOLTS 40 l' /

  • F—FILAMENT CURRENT [1]

    2 A

    F—FILAMENT CURRENT 2-5 AMPS 4

  • F—FILAMENT CURRENT [2]

    -5 A

    F—FILAMENT CURRENT 2-5 AMPS 4

  • F—FILAMENT CURRENT [3]

    4 A

    F—FILAMENT CURRENT 2-5 AMPS 4

  • ANODE VOLTS MAX [1]

    350

    ANODE VOLTS MAX 350+350 RMS, y. . y,

  • ANODE VOLTS MAX [2]

    350

    ANODE VOLTS MAX 350+350 RMS, y. . y,

  • large output valves of the PX

    4

    large output valves of the PX.4 type, : /

  • voltage. U [1]

    12 V

    voltage. U.12 is often used as a com- 20,

  • voltage. U [2]

    20 V

    voltage. U.12 is often used as a com- 20,

  • THE INPUT VOLTACE

    1

    THE INPUT VOLTACE 1S

  • AC voltage per anode

    250 V

    Maximum RMS input voltage, 250+250 V center-tapped.

  • Rectified current

    60 mA

    Maximum DC output current.

  • Rectifier impedance

    220 ohm

    Published approximate impedance.