TA10600

Directly heated high-mu transmitting triode for professional transmitter service, including marine equipment. Approximately 10 kV plate capability and very high amplification factor provide strong voltage gain for RF power stages.

Directly heatedCold cathodeCommon cathodeDissimilar

Sections: 1
Base: -
Socket code: -
Base pins: -
Nominal heater: 12.5 V / 63 A

Description

Directly heated transmitting triode intended for transmitter service, including marine use. The sheet specifies filament and anode conditions, dissipation, amplification factor, transconductance, and internal resistance.

General specifications

Tube and section characteristics

Properties common to every published source and operating point.

Heater and base

Base: -
Socket code: -
Base pins: -
Nominal heater voltage: 12.5 V
Nominal heater current: 63 A
Parallel heater voltage: -
Parallel heater current: -
Series capable: No

Terminal pinout

Electrical assignments shared by every tube using this base designation.

No verified pinout is recorded for this base designation.

Section ratings

1 physical section, each with unique specifications.

Section 1

Triode

X-ray radiationInterelectrode capacitances

Transconductance: 0.003 S
Amplification factor: 160
Max plate voltage: 10000 V
Max plate dissipation: 200 W

Transmitting triode

Source-dependent data

Operating conditions by source

Each block preserves the test conditions and published values from one reference. Values from different sources are intentionally kept separate.

Data set 01

1999 Philips E-Z

Published operating points and test conditions from this source.

SECTION 1

Triode

Other

N\
50 S
Heizspannung . . . . . . . . . . . . . . y=ca
125 V
Sittigungsstrom . . . . . . . . . . . . . ig
260 mA
Anodenspannung . v, = 40600—
-12000 V
Zuléssiger Anodenverlust. w,
200 W
Anodenverlust gepriift auf w,—
300 W
Steilheit . . .S =ca
1.7 mA
Sittigungsspannung in der Gitterfliche . vy = ca
500 V

Characteristic

Filament voltage Vi
125 V
Filament current I - appr
63 A
In conjunction with this valve, two Philips rectifying valves DA 10/550 Total emission I = appr
4 A
can be used. Anode voltage A max
10000 V
Max. permissible anode dissipation \\ [1]
4 a
Max. permissible anode dissipation \\ [2]
200 W
If no importance is attached to the construction as per drawing, Anode dissipation during test Wat
<300 W
Mutual conductance at |,
75 mA
these terminals with fixing clamp but only beaded leads. Internal resistance atl, Ri appr
120000 ohms