Skip to main content
Tube Tinker — Electron Tube Database
Alternatives & variationsDownload PDF datasheet

Voltage Regulator ·VoltageRegulator

QS15045

Single-gap 150 V gas stabilizer with ignition electrode and broad approximately 5–45 mA operating range.

Directly heatedCold cathodeCommon cathodeDissimilar
Sections
1
Base
-
Socket code
-
Base pins
-
Nominal heater
-

Description

A single-gap gas-filled voltage stabilizer providing approximately 150 V regulated output, intended for stabilized DC power supplies.

General specifications

Tube and section characteristics

Properties common to every published source and operating point.

Heater and base

Base
-
Socket code
-
Base pins
-
Nominal heater voltage
-
Nominal heater current
-
Parallel heater voltage
-
Parallel heater current
-
Series capable
No

Terminal pinout

Electrical assignments shared by every tube using this base designation.

No verified pinout is recorded for this base designation.

Section ratings

1 physical section, each with unique specifications.

Section 1

Voltage Regulator

X-ray radiationInterelectrode capacitances
Regulator voltage
150 V
Regulator minimum current
5 mA
Regulator maximum current
45 mA
Regulator starting voltage
170 V
Regulator maintaining voltage
150 V

Published maximum ratings and characteristics audited; remaining useful numerical data retained in parameter table.

Source-dependent data

Operating conditions by source

Each block preserves the test conditions and published values from one reference. Values from different sources are intentionally kept separate.

Data set 01

1955 Marconi

Published operating points and test conditions from this source.

SECTION 1

Voltage Regulator

Other

  • S VOLTAGE STABILISERS QS1 [1]

    8 V

    S VOLTAGE STABILISERS QS108/45

  • S VOLTAGE STABILISERS QS1 [2]

    45 V

    S VOLTAGE STABILISERS QS108/45

  • Stability {( [1]

    1000

    Stability {(1000 hr, period) T 2 ) %

  • Stability {( [2]

    2

    Stability {(1000 hr, period) T 2 ) %

  • + With ignition electrode connected to [1]

    150

    + With ignition electrode connected to 150 V supply via 100 kQ series resistor.

  • + With ignition electrode connected to [2]

    100

    + With ignition electrode connected to 150 V supply via 100 kQ series resistor.

  • tt+ With ignition electrode connected to [1]

    200

    tt+ With ignition electrode connected to 200 V supply via 100 kQ series resistor.

  • tt+ With ignition electrode connected to [2]

    100

    tt+ With ignition electrode connected to 200 V supply via 100 kQ series resistor.

  • calculating the value of series resistor, an ignition current of approximately

    10 mA

    calculating the value of series resistor, an ignition current of approximately 10 mA

  • Stabilized voltage

    150 V

    Published regulated voltage.

  • Tube current minimum

    5 mA

    Minimum maintaining current.

  • Tube current maximum

    45 mA

    Maximum operating current.

  • Ignition voltage

    170 V

    Published minimum or maximum ignition/start voltage as applicable.