PL5822

Water-cooled ignitron for frequency-changer resistance-welding service and related high-current control.

Directly heatedCold cathodeCommon cathodeDissimilarSpecialized

Description

Water-cooled ignitron for frequency-changer resistance-welding service; equivalent electrically to PL5822A except for thermostat provisions.

General specifications

Properties common to every published source and operating point.

Electrical assignments shared by every tube using this base designation.

No verified pinout is recorded for this base designation.

1 physical section, each with unique specifications.

Section 1

X-ray radiationInterelectrode capacitances

No fixed ratings are recorded for this section.

Water-cooled ignitron for frequency-changer resistance-welding service; equivalent electrically to PL5822A except for thermostat provisions.

Source-dependent data

Each block preserves the test conditions and published values from one reference. Values from different sources are intentionally kept separate.

Data set 01

Published operating points and test conditions from this source.

SECTION 1

Frequence de la tension d'alimentation
-60 Hz
Welding service | Frequence de la tension d'alimentation 50-60 c/s
to-ti (q
4 degC
Typical characteristics | to-ti (q = 6 1/min.) = max. 4 °C
Iap (max)(Tav = max
0.2 s
Welding service | Iap (max)(Tav = max. 0.2 sec) 0.166 0.166
Surge current
0.15 s
Welding service | Iap T(Isurge) = max.0.15 sec
Tension d'amorgage = max
200 V
Ignitor characteristics | Tension d'amorgage = max. 200 V
Courant d'amorcage = max
12 A
Ignitor characteristics | Courant d'amorcage = max. 12A
ou au courant sus-mentionnes = max
100 µsec
Ignitor characteristics | ou au courant sus-mentionnes = max. 100 µsec
pour
200 V
Ignitor characteristics | pour 1'amorgage = min. 200 V
Ignition time
100 µsec
Ignitor characteristics | ignition time of max.100 µsec. di/at = min.0.25 A/µsec)
Ignition time
250 mA
Ignitor characteristics | ignition time of max.100 µsec. di/at = min.0.25 A/µsec)

Firing current
-8 A
Ignitor characteristics | Firing current = 6-8A
requis (p.e. pour un temps d'amorgage de
100 µsec
Ignitor characteristics | requis (p.e. pour un temps d'amorgage de 100 µsec au

Data set 02

Published operating points and test conditions from this source.

SECTION 1

Application: Réglage des soudeurs 4 resistance avec trans
4 A
Application: Réglage des soudeurs 4 resistance avec trans-
Phase control angle
0 a
Phase control angle = 0
5)Max. value at the indicated voltage
5 Ma
5)Max. value at the indicated voltage
3) For other values of Igp the corresponding max. average
3 v
3) For other values of Igp the corresponding max. average