Tube cross-reference
PL36 alternatives, equivalents, and replacements
Review exact electrical variations and directional substitutions recorded for the PL36 power - tv horizontal output (sweep). Compare core specifications and verify every restriction before using a replacement.
Exact variations of PL36
These designations belong to the same electrical variation group. Their names may differ because of international standards, manufacturing tolerances, or materials, but they are recorded as electrically equivalent—not merely substitutes.
25E5 Power - TV Horizontal Output (sweep)
- Base
- Not recorded
- Socket
- Not recorded
- Base pins
- Not recorded
- Sections
- 1
- Heater voltage
- 25 V
- Heater current
- 0.3 A
Replacement tubes for PL36
The following tubes are recorded as possible replacements for PL36. This direction does not establish that PL36 can replace them.
Power - TV Horizontal Output (sweep)
The database records 25E5 as a possible replacement forPL36.
No special restrictions are recorded for this substitution.
| Specification | Original tube | Replacement |
|---|---|---|
| Tube type | Power - TV Horizontal Output (sweep) | Power - TV Horizontal Output (sweep) |
| Construction | BeamPower | BeamPower |
| Base | Not recorded | Not recorded |
| Socket | IO | Not recorded |
| Base pins | 8 | Not recorded |
| Sections | 1 | 1 |
| Heater voltage | 25 V | 25 V |
| Heater current | 0.285 A | 0.3 A |
Where PL36 can be used as the replacement
In these recorded relationships, PL36 is the replacement tube. The listed original tubes are not automatically suitable as replacements for PL36.
Power - TV Horizontal Output (sweep)
The database records PL36 as a possible replacement for25E5.
No special restrictions are recorded for this substitution.
| Specification | PL36 replacement | Original tube |
|---|---|---|
| Tube type | Power - TV Horizontal Output (sweep) | Power - TV Horizontal Output (sweep) |
| Construction | BeamPower | BeamPower |
| Base | Not recorded | Not recorded |
| Socket | IO | Not recorded |
| Base pins | 8 | Not recorded |
| Sections | 1 | 1 |
| Heater voltage | 25 V | 25 V |
| Heater current | 0.285 A | 0.3 A |
Verify before substituting
Matching a base or heater voltage is not enough to prove that two tubes are interchangeable. Check pin connections, heater current, maximum ratings, bias requirements, warm-up behavior, and the equipment manufacturer’s service documentation before making a substitution.
View the complete PL36 specifications →