Voltage - Triode (single) ·Triode
Directly heated OSRAM triode for amplification, detection, or low-power output service in battery-operated equipment.
OSRAM LP2 triode for amplification, detection, or power-output service as specified in the supplied datasheet.
European 4-pin base
General specifications
Properties common to every published source and operating point.
Electrical assignments shared by every tube using this base designation.
No verified pinout is recorded for this base designation.
1 physical section, each with unique specifications.
Section 1
Promoted values mapped from printed rating/approximate-data tables; additional operating points and capacitances retained as parameters.
Source-dependent data
Each block preserves the test conditions and published values from one reference. Values from different sources are intentionally kept separate.
Data set 01
Published operating points and test conditions from this source.
Published operating data
See source
Operating curves/table are present on the approved one-page source; values not promoted unless unambiguous in searchable text.
Data set 02
Published operating points and test conditions from this source.
Filament/heater voltage
2 V
Filament/heater current
200 mA
Amplification factor
2
Plate impedance
3900 ohm
Mutual conductance
3850 uS
Maximum anode voltage
150 V
Optimum load
9700 ohm
Anode current at 150 V
7 mA
Data set 03
Published operating points and test conditions from this source.
Amplification Factor
15
Plate Resistance
3900 ohm
Typical Anode Voltage
150 V
Typical Grid Bias
-4.5 V
Typical Anode Current
11.5 mA