Data set 01
1944 Hytron
Published operating points and test conditions from this source.
SECTION 1
Triode
Characteristics
Heater or filament voltage
1.4 V
Published nominal value
Heater or filament current
70 mA
Published nominal value
Voltage - Triode (single) ·Triode
HY113
Low-filament-power Bantam Junior triode designed for radio-frequency oscillator or detector service from a 1.4 V filament and low plate voltage.
Directly heatedCold cathodeCommon cathodeDissimilar
- Sections
- 1
- Base
- -
- Socket code
- -
- Base pins
- -
- Nominal heater
- 1.4 V / 70 mA
Description
BANTAM JR. SERIES Type HY113 Triode R. F. Oscillator or Detector Filament Voltage............ 1.4 volts Filament Current... ....70 ma. Plate Voltage...... ..45 volts Grid Voltage.................. —4.5 volts Plate Current........coocooveeeeece. 0.4 ma. Transconductance.......250 umhos. Amp. Factor ... 6.3 Plate Resistance ... 25,000 ohms $1.75 Net Type HY115 Pentode High Gain, High Impedance, Audio Voltage Amplifier Filament Voltage............. 1.4 volts Filament Current.. ...70 ma Plate Voltage........ 45 volts Screen Voltage.. ..22.5 volts Grid Voltage ... ~1.5 volts Av. Plate Current.......... 0. 03 ma. Av. Screen Current..... Av, Amp. Factor... Transconductance.. Plate Resistance.....
General specifications
Tube and section characteristics
Properties common to every published source and operating point.
Heater and base
- Base
- -
- Socket code
- -
- Base pins
- -
- Nominal heater voltage
- 1.4 V
- Nominal heater current
- 70 mA
- Parallel heater voltage
- -
- Parallel heater current
- -
- Series capable
- No
Terminal pinout
Electrical assignments shared by every tube using this base designation.
No verified pinout is recorded for this base designation.
Section ratings
1 physical section, each with unique specifications.
Section 1
Triode
X-ray radiationInterelectrode capacitances
- Plate resistance
- 25000 Ω
- Transconductance
- 0.00025 S
- Amplification factor
- 6.3
Promoted ratings/characteristics from HY113.pdf. Hytron HY113 Bantam Junior directly heated 1.4 V, 70 mA low-power battery triode for RF oscillator or detector service. Typical test point: plate 45 V, control grid -4.5 V and plate current 0.4 mA. Published intrinsic amplification factor 6.3, transconductance 250 µS and plate resistance 25000 Ω. The 45 V plate condition is typical, not an explicitly declared absolute maximum.
Source-dependent data
Operating conditions by source
Each block preserves the test conditions and published values from one reference. Values from different sources are intentionally kept separate.