Power - Beam (NOT sweep) ·BeamPower-BeamPower
Twin beam-power tube with center-tapped heater for RF power-amplifier and oscillator service at frequencies to approximately 200 MHz.
Twin beam-power tube with center-tapped heater for RF power amplifier and oscillator service to 200 MHz.
Septar 7-contact base
General specifications
Properties common to every published source and operating point.
Electrical assignments shared by every tube using this base designation.
No verified pinout is recorded for this base designation.
2 physical sections, each with unique specifications.
Section 1
Representative row for two electrically identical beam-tetrode sections; ratings vary by service condition.
Section 2
Second identical physical beam-power unit; added under physical-section-per-unit policy.
Source-dependent data
Each block preserves the test conditions and published values from one reference. Values from different sources are intentionally kept separate.
Data set 01
Published operating points and test conditions from this source.
HeaterOrFilamentVoltage
6.3 V
HeaterOrFilamentCurrent
1.6 A
FrequencyForMaximumRatings
200 MHz
Data set 02
Published operating points and test conditions from this source.
Transconductance
3500 µS
Amplification Factor
6.5
Maximum Plate Voltage
750 V
Maximum Screen Voltage
250 V
Maximum Plate Dissipation
20 W
Maximum Cathode Current
115 mA
Full-Input Operating Frequency Maximum
200 MHz
Power Output
36 W
ClassC,RF
Heater Voltage Series
12.6 V
Heater Current Series
800 mA
Heater Voltage Parallel
6.3 V
Heater Current Parallel
1.6 A
Typical Plate Voltage
600 V
Representative published point
Typical Plate Current
90 mA
Representative published point
Data set 03
Published operating points and test conditions from this source.
Grid1AnodeCapacitancePerElement
0.07 pF
InputCapacitancePerElement
8 pF
OutputCapacitancePerElement
3.8 pF
ScreenCathodeCapacitance
65 pF
MaximumHeaterCathodePeakVoltage
100 V
Typical Plate Voltage
600 V
Typical Screen Voltage
200 V
TypicalOutputPower
26 W