Rectifier - Half Wave ·Rectifier
Directly heated xenon-filled half-wave rectifier for high-voltage supplies over a wide temperature range. Rated for approximately 10 kV peak inverse voltage, 1.25 A DC output, and 5 A peak current.
Xenon-filled half-wave rectifier with high peak-current capability and a wide temperature range.
European 4-pin base
General specifications
Properties common to every published source and operating point.
Electrical assignments shared by every tube using this base designation.
No verified pinout is recorded for this base designation.
1 physical section, each with unique specifications.
Section 1
Published ratings and characteristics promoted where applicable.
Source-dependent data
Each block preserves the test conditions and published values from one reference. Values from different sources are intentionally kept separate.
Data set 01
Published operating points and test conditions from this source.
Supply frequency
50 Hz
ChokeInputFilter
Minimum cathode heating time
30 s
Maximum fault anode current
50 A
Maximum fault-current duration
0.1 s
Data set 02
Published operating points and test conditions from this source.
Filament heating time
30 s
Tube voltage drop
10 V
Peak inverse anode voltage
10000 V
Peak anode current
5 A
Average anode current
1.25 A
Surge current
50 A
Data set 03
Published operating points and test conditions from this source.
Heater Warmup Time
5 s
MaximumSurgeCathodeCurrent
50 A
Data set 04
Published operating points and test conditions from this source.
Filament heating time
30 s
HalfWave;Xenon
Tube voltage drop
10 V
HalfWave;Xenon
Peak inverse anode voltage maximum
10000 V
HalfWave;Xenon
Peak anode current maximum
5 A
HalfWave;Xenon
Average anode current maximum
1.25 A
HalfWave;Xenon
Surge current maximum
50 A
HalfWave;Xenon
Data set 05
Published operating points and test conditions from this source.
Filament voltage
5 V
Filament current
7.1 A
Minimum filament heating time
30 s
Fault current
50 A
0.1 s maximum
Maximum power-supply frequency
150 Hz