Rectifier - Half Wave ·Rectifier
Directly heated oxide-filament half-wave mercury-vapor rectifier for power conversion. Rated for approximately 1.6 kV peak inverse voltage, with published operating conditions covering multi-valve rectifier circuits.
Directly heated oxide-filament mercury-vapour rectifier with 1.6 kV peak inverse rating and published multi-valve rectifier circuit operating conditions.
European 4-pin base
General specifications
Properties common to every published source and operating point.
Electrical assignments shared by every tube using this base designation.
No verified pinout is recorded for this base designation.
1 physical section, each with unique specifications.
Section 1
Published ratings/characteristics promoted; remaining useful source values represented as parameters.
Source-dependent data
Each block preserves the test conditions and published values from one reference. Values from different sources are intentionally kept separate.
Data set 01
Published operating points and test conditions from this source.
Time delay
30 s
Heating period after transport
15 min
Recommended ambient temperature minimum
10 degC
Recommended ambient temperature maximum
50 degC
Typical load voltage
500 V
Circuit2;TwoValves
Typical load current
450 mA
Circuit2;TwoValves
Data set 02
Published operating points and test conditions from this source.
Heater/filament voltage
1.8 V
Heater/filament current
5 A
Maximum peak inverse voltage
1600 V
Maximum peak anode current
750 mA