1LD5

Battery diode-pentode combining signal detection with relatively high-gain voltage amplification. The diode supplies detector action while the pentode provides subsequent gain from low-voltage portable receiver supplies.

Directly heatedCold cathodeCommon cathodeDissimilar

Sections: 2
Base: 6AX
Socket code: B8G
Base pins: 8
Nominal heater: 1.4 V / 50 mA

Description

1LD5 is listed as a diode sharp-cutoff pentode in the supplied receiving-tube handbook. It uses a 1.4 V, 0.05 A directly heated filament. The handbook publishes maximum ratings and representative operating characteristics for its intended service.

Socket description

Loctal 8-contact

General specifications

Tube and section characteristics

Properties common to every published source and operating point.

Heater and base

Base: 6AX
Socket code: B8G
Base pins: 8
Nominal heater voltage: 1.4 V
Nominal heater current: 50 mA
Parallel heater voltage: -
Parallel heater current: -
Series capable: No

6AX - Terminal pinout

Electrical assignments shared by every tube using this base designation.

No verified pinout is recorded for this base designation.

Section ratings

2 physical sections, each with unique specifications.

Section 1

Diode

X-ray radiationInterelectrode capacitances

No fixed ratings are recorded for this section.

Diode detector section; maximum diode drop 10 V at 0.5 mA.

Section 2

Pentode

X-ray radiationInterelectrode capacitances

Plate resistance: 750000 Ω
Transconductance: 0.000875 S
Max plate voltage: 110 V
Max screen voltage: 40 V

Pentode audio-amplifier section.

Source-dependent data

Operating conditions by source

Each block preserves the test conditions and published values from one reference. Values from different sources are intentionally kept separate.

Data set 01

195X General Electric Essential Characteristics

Published operating points and test conditions from this source.

SECTION 2

Pentode

Other

Maximum plate voltage
110 V
Published handbook rating
Maximum screen voltage
45 V
Published handbook rating
Plate voltage
90 V
ClassA
Screen voltage
45 V
ClassA
Control-grid voltage
0 V
ClassA
Plate current
0.6 mA
ClassA
Screen current
0.1 mA
ClassA

Characteristic

Plate resistance
750000 ohm
Published handbook characteristic
Transconductance
575 µS
Published handbook characteristic
Filament voltage
1.4 V
DirectlyHeated DC filament
Filament current
50 mA
DirectlyHeated DC filament

Data set 02

1961 Tung Sol

Published operating points and test conditions from this source.

SECTION 2

Pentode

Other

MaximumDiodeDrop
10 V
DiodeCurrent=0.5mA